How To Adding Electric Heat Option To An RV’s Propane Heater

Rv Heating

A little bit about the product which basically helps you to adding electric heat option to an RV’s propane heater is an add-on component to your existing propane furnace and what it does is allow you create an add-on component without heating coil whereby you use electricity to heat the coach instead of burning propane in your furnace.

If you looking for an electric heater for your RV check out this post here: https://innovatecar.com/best-electric-heater-for-rv/

How To Adding Electric Heat Option To An RV's Propane Heater

Why You Need An Electric Heat Option

When you’re in a campground of electricity available why not use the electric heat that’s available instead of burning your onboard propane and then when you go on the road obviously flip a switch and you go back over to the propane side of your furnace or your heating system very similar to what some water heaters do with electric heating coil in the water heater as well as burning propane to create the heat.

About the coil one of the challenges has been in the process of designing is be able to provide enough heat to actually heat the RV cleared out of those colder temperatures.

Yours limited with the electric plug-in heater in as much as you only got as many powers provide and that’s about 1500W plus

With this thing depending on the size of shore power with the new RV you find that most of them are coming out with 50Amp this thing will generate 5000 W worth of heat. Unlike a gas furnace which is about 60% efficient, this is 100% efficient

What we found in the RV that we get this thing installed in we’ve got we got people that are living in RVs that are 38-40 feet at 9°C.

We’ve got people are heating their RVs 100% with this running absolutely no gas and still have reserve heat the fan furnace cycling on and off.

Pros And Cons Of Electric Heat Option

One of the advantages also with this is we have the ability to have three different heat level.

We’ve also got the fans and may not move as much air we’ve got RVs that have a 50 amp circuit.

The uniqueness of this coil is depending on which one you select this or run on 115 V or 30 An or those around 250 V on the 50

It’s basically all in one. The way the system design we tried to make it so we could cover the RV industry from the smaller 24 -40 footers and be able to do it with one system

By holding it on this one system it allows us to have the safeties associated with all three different heat level are common to all of them this system unlike again electric plug-in heaters has redone the safety. It has two automatic high limit temperature switches that will add 200° will shut the system down.

Pros and Cons of Mount a light Bar

If one fails then the other one kicks in. These things here at 333°C internally open up and then they shut down there’s nothing you can do to make it run. If you close off all the registers of the fan fails if anything goes wrong these things are going to burn through internally and they won’t cause a fire

This actually has more safety features than gas furnaces. This is after the furnace what happens is where using the fan this is attached at the end. the air blows through the furnace since the gas furnaces and on then this does all the heating of the air pushes out the culture was good to go.

We’ve done temperature checks with this stuff and in some cases, we’ve actually had were this thing produces more heater. depends on the installation and depends on the dock runs but we met temperatures up to 145°C.

If it’s on the suburban furnace and the Atwood Hydro flame now that being said the issue is clearances anyone of the furnaces is gone on its gonna have clearance

In most cases, you find that it takes a roughly additional 6 inches added onto the overall length of the furnace.

So if you’ve got the dock on the end of the furnace that is sticking out you gonna end at about 6 inches into that length.

There’s a compatibility chart and it actually breaks down and it tells you what size shore power you have what model of furnace. It’ll even take the clearances down to an eighth of an inch of what you need to be of the put this in. Pictures were 10,000 words that way we can help the installer make sure that you select the correct product for the job we can make sure that the clearances are there.

Rv Heating

Things You Need To Consider Before Adding Electric Heat Option

There are a couple things we need to know we need to know what size shore power you got

a manufacturer name of the furnace and preferably a model number.

Make sure he lets let them know the year and brand of the RV the year model number and the type of furnace that’s in your in your coach as well this is not really a do-it-yourself homeowner project

We only sell this through RV dealers this is a fairly complicated process it’s nothing that is a qualified RV installation facility can’t handle but you are dealing with a line voltage or residential style high-voltage as well as a 12 V and you want to make sure not to mix those right up whenever you get them certified technician is the best way.

The controller that actually we use that runs the system. we actually went to a lot of trouble designing this controller this thing is over-engineered as you can get.

the circuit strips and you see how wide these strips are these electrical panels are designed for an excessive 30 A

The fans in the furnaces draw a roughly 10 -20 Amp relays. The speed controller we designed such a manner to wear that this thing has a solid copper in getting across the back of it that you can see is actually screwed in the back and it uses this whole box is a heatsink that way if the installer decides the stuff this someplace underneath your RV or you can’t get to it you don’t have to worry about this thing overheating because it uses this whole box and your speed controller that you’re looking at in the center

Last one of the nice things about this from the consumer standpoint they use the same thermostat all of the controls in the coach of the same

The only difference is they have a switch and that’s installed wherever it’s convenient and it’s just a matter of bacon between gas and electric there’s nothing else to do

A separate circuit breaker that they can turn on or turn off if it resets you should never the problem with it.

Conclusion

These are all the things you need to know before upgrade your RV heating system. For this more information, you can check out other our post on the blog here to find a good electric heater if you looking for it.

0 Comments

Leave a Reply

Your email address will not be published.

shares